Resource not updating in exchange 2016

The entire process after confirming the administrator password should take less than 10 minutes, so as long as the gear icon is still spinning do not reboot the phone, just wait for the eventual reboot.

On some early models of the Trio the USB process may not work as described above.

From a software standpoint the Trio platform is based on the same (UCS) platform that the entire line of modern VVX phones use, thus the majority of upgrade options are the same.

As covered in various other VVX articles this process is unchanged in the Trio.

After a few minutes the USB drive activity light should stop flashing which means the files are finished copying to the phone.

In fact this is a very similar process to what the CX5100/5500 also supports for firmware upgrading.

The steps for installing cumulative updates and service packs on Exchange 2013 are: If you have multi-role CAS/MBX servers installed then setup updates the roles in the correct order anyway, and you should simply start with the internet-facing servers.

During the deployment of a cumulative update within a site that contains load-balanced Client Access server or Database Availability Group members there will be a period where servers are not at exactly the same version.

In fact there is nothing else which must be configured is the environment is already setup to support existing VVX phones.

As stated because the Trio uses the same base UCS platform then the Trio will adhere to any existing DHCP, LLDP, or other network configuration parameters specific to the IP phones. The Microsoft native firmware update process that was added to Lync Server 2010 to support Lync Phone Edition devices has been supported by Polycom VVX phones for over two years now, as of the initial 5.0 firmware release.

Leave a Reply